Baileigh WR-510 ATC CNC Router
Serial # F160201
Large 5’ x 10’ table.
Arrives pre-built with correct alignment. No complicated set-up process.
Comes with software for plotting out designs on your computer, then turning them into cut patterns for the machine.
Runs on 220-volt 3-phase power.
Powerful 7.3 hp spindle can tackle hard materials without flinching.
5.5 kilowatt water-cooled spindle will stay accurate through years of production.
Variable spindle speed, from 3,000 to 18,000 rpm.
Yaskawa brand servo motors ensure smooth running at both fast and slow speeds.
High gantry is up and away from material, allowing you to see what it’s doing.
Y axis moves far enough for the gantry to clear the table. You can take the material directly off; no need slant it awkwardly.
Upload your design to the table with a USB drive.
You can operate the machine from the console podium.
Automatic tooling changes let you swap out bits with computer-controlled precision.
Sensor compensates for the change in tool lengths. That change might seem tiny, but it makes a huge difference to the finished product.
Pre-load up to 7 collets with your chosen profiles; the router will switch between them as programmed.
Powerful vacuum in the bed of the table holds the material in place during the cutting process.
6 vacuum zones allow you to turn on the valve only for the area where you’re working.
Arrange each zone’s vacuum seal into the shape of the material to provide well-distributed suction.
Dust shroud fits over the spindle; you can vacuum out all the dust and chips while you’re cutting.
Fully-welded steel frame keeps the machine stable, helping the router last longer and preventing vibrations from taking the cut off-course.
You can count on lifetime technical support by phone from Baileigh’s team of reps, all with hands-on product experience.
Freight and Installation will be an additional cost.
Note: There may be some variances in the above features.